Wood Chip Dryer Manufacturer in Austria
See how we dry Wood ChipLooking for wood chip dryer manufacturers in Austria? STRONGA builds FlowDrya lines to order at its Hertfordshire works and supplies them to Austria — see the regulatory and economic context below.
FlowDrya wood-chip dryers are built to order at STRONGA's Hertfordshire works and supplied to sawmills, biomass and district-heating operators here, and we say plainly that no wood-chip line is yet commissioned on home soil. Freshly comminuted chip leaves the forest wet and unstable; a boiler or a pellet press wants it dry and graded. Conditioning the chip to a low, even moisture raises its net calorific value, steadies combustion and lets it be classified against EN ISO 17225-4 with moisture reported to EN ISO 18134. Because this is one of Europe's most forest- and biomass-rich economies, a dryer that turns green chip into a documented, storable fuel sits at the centre of the domestic wood-energy chain.
Supplying Austria
We supply Austria from our Hertfordshire works — we have no documented Wood Chip installation in Austria yet.
Regulatory context
The Abfallwirtschaftsgesetz 2002 (AWG 2002) is Austria's framework waste statute and transposes the EU Waste Framework Directive into national law. It fixes a five-step waste hierarchy — prevention, preparation for re-use, recycling, other recovery including energy recovery, and disposal only as a last resort — so an operation that dries a wet residue into a fuel or a soil product counts as recovery and ranks above burial in the legal order.
Source: https://www.ris.bka.gv.at/GeltendeFassung.wxe?Abfrage=Bundesnormen&Gesetzesnummer=20002086 · checked 2026-08
Austria was an early mover against landfill. Under the Deponieverordnung, waste exceeding a strict five per cent total-organic-carbon limit — untreated municipal waste and the combustible residual fraction within it — may not be landfilled; the ban was phased in from 2004 and consolidated in the Deponieverordnung 2008. Cheap burial of wet, biodegradable residue is therefore closed off, which pushes such material toward pre-treatment, drying and recovery rather than a hole in the ground.
Source: https://www.ris.bka.gv.at/GeltendeFassung.wxe?Abfrage=Bundesnormen&Gesetzesnummer=20005653 · checked 2026-08
Compost and solid digestion products made from waste can shed their waste status and be marketed as quality compost once they satisfy the Kompostverordnung (BGBl. II No. 292/2001), which fixes the permitted raw materials, quality classes, labelling and contaminant limits a product must hold. A dried, stabilised feedstock holds those quality bands far more easily than a wet, actively degrading one, and is far cheaper to store and transport.
Source: https://www.ris.bka.gv.at/GeltendeFassung.wxe?Abfrage=Bundesnormen&Gesetzesnummer=20001486 · checked 2026-08
Applicable standards: EN ISO 21640, EN ISO 17225-4, EN ISO 18134, Kompostverordnung (BGBl. II No. 292/2001) quality classes.
Economic context
Austria prices carbon on heating, transport and small-industry fuels through its national emissions trading scheme (Nationaler Emissionszertifikatehandel, NEHG), introduced in 2022. The fixed price reached 55 euros per tonne of CO2 in 2025 and remains at 55 euros in 2026, holding until the EU ETS 2 for buildings and road transport starts in January 2028; heavy industry sits under the EU Emissions Trading System. Displacing coal or petcoke with a dried waste- or biomass-derived fuel avoids a real per-tonne charge.
Source: https://icapcarbonaction.com/en/ets/austrian-national-emissions-certificate-trading-system · checked 2026-08
Bought-in energy is a real cost. Statistics Austria reports a gross electricity price of 0.293 euros per kWh and a gross natural gas price of 0.126 euros per kWh. High delivered energy prices favour drying systems built around recovered kiln, boiler or flue heat rather than grid electricity or bought-in gas.
Source: https://www.statistik.at/en/statistics/energy-and-environment/energy/energy-prices-taxes · checked 2026-08
Electricity from solid biomass and biogas is supported under the Erneuerbaren-Ausbau-Gesetz (EAG, Renewable Energy Expansion Act) of 2021 through market premiums and technology tenders, part of Austria's statutory targets of 100 per cent renewable electricity by 2030 and climate neutrality by 2040. Austria runs one of Europe's most biomass-intensive energy systems, so a dried biomass or biogas fuel feeds an established, incentivised renewable market rather than a marginal one.
Source: https://www.ris.bka.gv.at/GeltendeFassung.wxe?Abfrage=Bundesnormen&Gesetzesnummer=20011619 · checked 2026-08
Worked illustration (assumptions stated):
The case rests on biomass demand and dear bought-in energy. Solid-biomass electricity and heat are supported under the EAG, part of the drive to 100 per cent renewable electricity by 2030, so a dried, graded chip feeds an established, incentivised market. Every point of moisture removed lifts the delivered energy per tonne and cuts haulage, and with gross gas at 0.126 euros per kWh and electricity at 0.293 euros per kWh, running the dryer on recovered boiler or flue heat rather than bought-in energy protects the margin. A wet, mouldering chip is discounted; a dry, classified one earns a firm price. Assumptions: heat source, species and offtake govern the payback.
Figures are indicative and were last reviewed August 2026; energy and disposal prices move — contact us for a current assessment.
Wood Chip Dryer Manufacturer in Austria — FAQ
Do you have a wood-chip dryer here yet?
No, and we will not imply one. Each FlowDrya is built to order in Hertfordshire and commissioned on site; our documented references dry woodchips, bark and digestion fibre in Britain on the identical platform.
Why dry wood chip at all?
Green chip near half moisture burns inefficiently and rots in the pile. Drying to a low, even level raises net calorific value, halts microbial degradation and lets the fuel be stored and graded to a standard buyers recognise.
Which standard classifies dried wood chip?
Wood chips for energy are specified under EN ISO 17225-4, with moisture determined to EN ISO 18134. Drying to a documented, repeatable moisture band is what makes that classification consistent load after load.
What heat can run the dryer?
FlowDrya is designed around low-grade recovered heat – spare boiler, flue or process heat – transformed into drying-quality air, so a biomass or sawmill site rarely needs to buy in energy to dry its own chip.
Does drying strengthen the biomass business case?
Yes. Biomass heat and power are incentivised under the EAG, and a dried, classified chip commands a firmer, more predictable offtake than a wet, variable one across the domestic wood-energy sector.
How is a wood-chip dryer delivered, and what output can it hit?
Each dryer is fully assembled and factory-tested, then dismantled for freight and rebuilt on arrival, connected to the sawmill or boiler-house heat supply and brought online through a structured start-up, shutdown and supervised trial before handover. Output is matched to throughput; the deep bed accepts variable chip sizes without prior screening or pre-drying, yielding a uniform, graded fuel ready for storage or dispatch.