Wood Chip Dryer Manufacturer in Australia
See how we dry Wood ChipLooking for wood chip dryer manufacturers in Australia? STRONGA builds FlowDrya lines to order at its Hertfordshire works and supplies them to Australia — see the regulatory and economic context below.
FlowDrya woodchip drying plants are built to order at STRONGA's Hertfordshire works and supplied to producers here, and we are candid that no woodchip line is documented on this side of the world yet. Dry, uniform chip burns cleaner and hotter in biomass boilers, combined-heat-and-power units and district-energy schemes, and a low, even moisture is what lets a producer meet the woodchip classes of EN ISO 17225-4. With a large forestry and wood-processing sector and abundant plantation and sawmill residue, the feedstock is plentiful; the constraint is turning green chip near 65% moisture into a stable fuel below 20%. FlowDrya's moving-floor bed and PulseWave agitation tumble the material so it dries evenly rather than sitting wet in a static heap, while sub-deck screening lifts out fines and grit during the pass.
Supplying Australia
We supply Australia from our Hertfordshire works — we have no documented Wood Chip installation in Australia yet.
Regulatory context
Waste is regulated by the states and territories rather than by a single national permit, so a plant that stores, treats or dries a waste-derived material is licensed by the relevant state environment regulator — for example under the New South Wales Protection of the Environment Operations Act 1997, administered by the NSW EPA — and most states also apply a waste levy on material sent to landfill, which is the principal lever pushing wet residues toward recovery, drying and reuse.
Source: https://www.epa.nsw.gov.au/Your-environment/Waste/waste-levy · checked 2026-08
Under the Commonwealth Recycling and Waste Reduction Act 2020, Australia bans the export of unprocessed waste glass, plastic, paper and tyres; these materials may only be exported once they have been processed into a value-added form, which increases domestic demand for on-shore processing, drying and conversion of waste-derived materials into usable products and fuels.
Source: https://www.dcceew.gov.au/environment/protection/waste/exports/waste-exports-and-the-law · checked 2026-08
The Safeguard Mechanism, reformed from 1 July 2023, sets declining emissions baselines for facilities that emit more than 100,000 tonnes of CO2e a year, with those baselines falling by 4.9 per cent each year to 2030; cement kilns, lime plants and other large emitters that exceed their baseline must surrender carbon units, which rewards displacing coal and gas with a dried, waste-derived alternative fuel.
Source: https://www.dcceew.gov.au/climate-change/emissions-reporting/national-greenhouse-energy-reporting-scheme/safeguard-mechanism · checked 2026-08
Composts, soil conditioners and mulches sold in Australia are specified by the Standards Australia standard AS 4454, which sets the physical, chemical, biological, maturity and labelling requirements a product derived from composted organic material must meet before it can be marketed — the quality regime a dried digestate, manure or organic-fraction amendment must satisfy to be placed on the market.
Source: https://store.standards.org.au/product/as-4454-2003 · checked 2026-08
Applicable standards: EN ISO 21640, EN ISO 17225-4, EN ISO 18134, AS 4454, NSW EPA Biosolids Guidelines.
Economic context
State waste levies make disposal expensive: in Victoria the metropolitan levy is AUD 169.79 per tonne for both municipal and industrial waste in 2025-26 (EPA Victoria), one of the higher rates among the states, so every tonne of water or inert material kept out of landfill is a direct and rising saving.
Source: https://www.epa.vic.gov.au/waste-levy · checked 2026-08
Wholesale electricity spot prices averaged about AUD 83 per megawatt hour across the National Electricity Market in the first quarter of 2025 (AEMO Quarterly Energy Dynamics), so a dryer that runs on recovered process heat and draws little grid power protects the operating margin.
Source: https://www.aemo.com.au/-/media/files/major-publications/qed/2025/qed-q1-2025.pdf · checked 2026-08
East-coast wholesale gas prices averaged about AUD 13.26 per gigajoule in the first quarter of 2025, a record high for the period (AEMO Quarterly Energy Dynamics), which favours drying systems built around recovered kiln, boiler or process heat rather than bought-in gas or electric heating.
Source: https://www.aemo.com.au/-/media/files/major-publications/qed/2025/qed-q1-2025.pdf · checked 2026-08
Australian Carbon Credit Units traded at AUD 33.08 on 31 March 2025 (Clean Energy Regulator); a Safeguard facility that exceeds its baseline can surrender ACCUs to cover the excess, so each tonne of coal a dried alternative fuel displaces avoids both the fuel cost and a carbon-unit liability.
Source: https://cer.gov.au/markets/reports-and-data/quarterly-carbon-market-reports/quarterly-carbon-market-report-march-quarter-2025/safeguard-and-australian-carbon-credit-unit-accu-schemes · checked 2026-08
Worked illustration (assumptions stated):
For wood chip the sum is heat displaced against heat spent. Dry chip meeting EN ISO 17225-4 lets a boiler run at rated output and displaces bought-in fuel, whereas wet chip forces the boiler to evaporate water instead of delivering useful heat. The economics reward taking drying energy from a boiler flue, a biomass furnace or a CHP jacket rather than the grid, which matters when wholesale electricity averaged about AUD 83 per megawatt hour and wholesale gas about AUD 13.26 per gigajoule in early 2025. Off-spec chip that would otherwise be dumped also escapes a landfill levy reaching AUD 169.79 per tonne in some states. Assumptions: your fuel contract, region and heat source set the real return.
Figures are indicative and were last reviewed August 2026; energy and disposal prices move — contact us for a current assessment.
Wood Chip Dryer Manufacturer in Australia — FAQ
Do you supply wood chip dryers here?
Yes. Every FlowDrya is engineered and assembled at STRONGA's Hertfordshire factory, factory-tested, then shipped and commissioned on the customer's site with operator training before handover.
What moisture standard should dried wood chip meet?
Woodchip for combustion is classified under EN ISO 17225-4. A stable low moisture keeps a batch within its declared class, which is what boiler operators and fuel buyers require for predictable output.
Do you have a wood chip installation here?
Not yet, and we will not imply one. Our documented woodchip, bark and digestate lines are in Britain, all running the same moving-floor technology a project here would use.
Which sectors buy dried wood chip here?
District-energy schemes, institutional and commercial biomass boilers, glasshouse and poultry heating, and pellet producers all favour a high-energy chip that ignites readily and stores without composting or fungal spoilage.
Can FlowDrya handle sawmill and arboricultural chip alike?
Yes. The moving-floor bed copes with the variable particle sizes and contamination typical of tree-surgery arisings and mill residue, screening fines beneath the deck while the coarser chip continues drying above.