Municipal Solid Waste Dryer Manufacturer in the United Kingdom
See how we dry Solid WasteLooking for MSW dryer manufacturers in the United Kingdom? STRONGA builds FlowDrya lines to order at its Hertfordshire works and supplies them to the United Kingdom — see the regulatory and economic context below.
FlowDrya municipal-solid-waste dryers are manufactured to order at STRONGA's Hertfordshire works and supplied throughout Britain. We are candid that we have no documented MSW drying reference on British soil yet – but the driver is unmistakable. British policy is steadily squeezing residual waste out of landfill, and mechanical-biological and energy-from-waste operators need a drier, more consistent output to recover fuel and recyclate efficiently. Drying mixed waste on a FlowDrya moving-floor bed reduces weight, stabilises the material against odour and biological activity, and improves the separation of a combustible fraction from the inert remainder, making the whole treatment train work harder.
Supplying the United Kingdom
We supply the United Kingdom from our Hertfordshire works — we have no documented Solid Waste installation in the United Kingdom yet. Our FlowDrya projects in the United Kingdom to date cover other materials:
Regulatory context
Operating a plant that stores, treats or dries a waste-derived or organic material normally requires an environmental permit from the Environment Agency (or the devolved regulator in Scotland, Wales and Northern Ireland); the operator must demonstrate technical competence and comply with the permit conditions.
Source: https://www.gov.uk/guidance/waste-environmental-permits · checked 2026-08
Exporting waste-derived fuel such as RDF or SRF abroad is controlled under the assimilated Waste Shipments Regulation: most movements to recovery in the EU require prior written notification and consent from all competent authorities (amber-list controls), and the export of domestically derived RDF to non-OECD countries is prohibited.
Source: https://www.gov.uk/guidance/importing-and-exporting-waste · checked 2026-08
Solid recovered fuel produced from non-hazardous waste is specified and classified under EN ISO 21640, which assigns classes on net calorific value, chlorine content and mercury content so the fuel can be traded and burned consistently in cement and lime kilns.
Source: https://www.iso.org/standard/71309.html · checked 2026-08
Applicable standards: EN ISO 21640, EN ISO 17225-4, PAS 110, PAS 100.
Economic context
Landfill Tax on the disposal of most active waste in England and Northern Ireland is £130.75 per tonne from 1 April 2026 (the lower rate for inert waste is £8.65 per tonne); Scotland and Wales apply aligned devolved rates. The escalating tax is the primary economic driver for diverting material away from landfill.
Source: https://www.gov.uk/government/publications/rates-and-allowances-landfill-tax/landfill-tax-rates-from-1-april-2013 · checked 2026-08
The median UK gate fee for non-hazardous landfill, excluding Landfill Tax, was £34 per tonne in WRAP's UK Gate Fees Report 2025-26, and median energy-from-waste gate fees rose again across all categories surveyed.
Source: https://www.wrap.ngo/resources/report/uk-gate-fees-report-2025-26 · checked 2026-08
UK manufacturers paid an average of 17.08 pence per kWh for electricity and 3.71 pence per kWh for gas in Quarter 2 2025 (DESNZ Quarterly Energy Prices, September 2025). High industrial electricity prices reward drying equipment that runs on recovered waste heat and minimal electrical power rather than direct electric heating.
Source: https://assets.publishing.service.gov.uk/media/68da5e91dadf7616351e4b5e/quarterly-energy-prices-september-2025.pdf · checked 2026-08
Worked illustration (assumptions stated):
The economics of drying municipal waste are dominated by the cost of not diverting it. Landfill Tax stands at £130.75 per tonne from April, with a landfill gate fee near £34 per tonne on top, while energy-from-waste gate fees are rising again – so every tonne kept out of a hole and turned into fuel or recyclate is worth real money. Drying lifts the calorific value of the combustible fraction and cuts the tonnage hauled. FlowDrya is built to run on recovered heat rather than costly grid power, which matters where British electricity averages 17.08 pence per kWh. Assumptions: gate fees and offtake vary by region and contract; the figures quoted are national references.
Figures are indicative and were last reviewed August 2026; energy and disposal prices move — contact us for a current assessment.
Municipal Solid Waste Dryer Manufacturer in the United Kingdom — FAQ
Do you have a UK municipal solid waste installation?
Not yet, and we will not imply one. Our documented British installations dry bark, digestate fibre and woodchips; they run the same FlowDrya platform an MSW drying plant would use.
Why dry municipal solid waste in Britain?
Rising Landfill Tax and residual-waste-reduction policy push mixed waste toward recovery. A drier, more stable feed improves fraction separation and raises the calorific value of the fuel sent to energy-from-waste, so the treatment plant recovers more from each tonne.
Which permits apply to an MSW drying plant?
A plant storing and treating municipal solid waste normally needs an environmental permit from the Environment Agency, and any waste-derived fuel exported for recovery abroad falls under waste-shipment notification controls.
How does drying improve waste sorting and recovery?
A drier feed flows better across screens and separators, so metals, plastics and inert grit part more cleanly from the combustible fraction, raising recyclate purity and the quality of the recovered fuel.
What treatment routes suit dried municipal waste?
Mechanical-biological treatment, refuse-derived-fuel production and energy-from-waste all perform better on a stabilised, low-moisture input than on heavy, decomposing mixed refuse.
Does drying help meet landfill-diversion targets?
Directly. Converting a wet residual stream into recoverable fuel and cleaner recyclate keeps biodegradable mass out of landfill, supporting the operator's diversion obligations and the wider policy push toward a circular economy.
Can dried municipal waste be stored before processing?
Yes. A stabilised, low-moisture output resists the heating and odour that plague wet stockpiles, so a plant can buffer material safely and feed downstream equipment at a steady, controlled rate.