Municipal Solid Waste Dryer Manufacturer in Canada
See how we dry Solid WasteLooking for MSW dryer manufacturers in Canada? STRONGA builds FlowDrya lines to order at its Hertfordshire works and supplies them to Canada — see the regulatory and economic context below.
Built to order at STRONGA's Hertfordshire works, FlowDrya municipal-waste dryers are supplied nationwide, and we say plainly that we have no commissioned MSW reference here to point to yet. Two forces are tightening the residual-waste stream: provincial diversion policy, including organics bans, and an industrial carbon price that rewards recovering fuel over burying it. Because municipal waste falls under provincial rather than federal permitting, the exact route to consent varies by jurisdiction. Passing mixed refuse over a FlowDrya moving-floor bed sheds weight, quiets the biological activity that causes odour, and loosens the combustible fraction from the inert remainder – so screens, magnets and separators downstream each recover more from the same input.
Supplying Canada
We supply Canada from our Hertfordshire works — we have no documented Solid Waste installation in Canada yet.
Regulatory context
Waste management is largely a provincial responsibility, so a plant that stores, treats or dries a waste-derived material is authorised under provincial law — for example British Columbia's Environmental Management Act and its Organic Matter Recycling Regulation, or Ontario's Environmental Protection Act — and the exact permitting a drying or fuel-preparation site faces varies by province rather than being set by a single national rule.
Source: https://www2.gov.bc.ca/gov/content/environment/waste-management/food-and-organic-waste/regulations-guidelines · checked 2026-08
The federal consumer fuel charge was set to zero on 1 April 2025, but federal industrial carbon pricing continues to apply to large emitters through the Output-Based Pricing System, so cement kilns, lime kilns and energy-from-waste plants still carry a price on their fossil-fuel combustion — an ongoing incentive to substitute conventional fuel with a dried, waste-derived alternative.
Source: https://www.canada.ca/en/department-finance/news/2025/03/removing-the-consumer-carbon-price-effective-april-1-2025.html · checked 2026-08
Provincial policy is steadily diverting organic material away from disposal: Ontario's Food and Organic Waste Framework directs municipalities and businesses to collect and recover organics, while Quebec is phasing out the landfilling and incineration of organic materials and extending organics collection to households, institutions and industry — pressure that pushes wet residues toward stabilisation, composting and anaerobic digestion.
Source: https://www.ontario.ca/page/food-and-organic-waste-framework · checked 2026-08
Applicable standards: EN ISO 21640, EN ISO 17225-4, EN ISO 18134, CCME Guidelines for Compost Quality, CAN/BNQ 0413-200 compost standards.
Economic context
At Metro Vancouver's regional solid-waste facilities the garbage tipping fee is CAD 148 per tonne for municipal garbage and CAD 162 per tonne for commercial loads of 1 to 7.99 tonnes (rates in effect 2026), and loads containing banned recyclable or organic material attract a surcharge — so avoiding disposal is a real and rising saving.
Source: https://metrovancouver.org/services/solid-waste/tipping-fee · checked 2026-08
The federal industrial carbon price (the Output-Based Pricing System excess-emissions charge) is CAD 95 per tonne of CO2e in 2025 and rises by CAD 15 each year — to CAD 110 in 2026 and CAD 170 by 2030 — which steadily improves the economics of displacing coal or petroleum coke in a kiln with a dried, waste-derived fuel.
Source: https://icapcarbonaction.com/en/ets/canada-federal-output-based-pricing-system · checked 2026-08
The Alberta AECO-C benchmark natural-gas price is forecast at CAD 2.71 per gigajoule for 2025 (Alberta Energy Regulator) — inexpensive by international standards, which favours drying systems built around gas-fired or recovered process heat rather than electric heating.
Source: https://www.aer.ca/data-and-performance-reports/statistical-reports/alberta-energy-outlook-st98/prices-and-capital-expenditure/natural-gas-prices/aeco-c-price · checked 2026-08
Industrial electricity prices differ sharply by province: hydro-rich Quebec, Manitoba and British Columbia are among the lowest-priced jurisdictions in North America, while Alberta, Saskatchewan, Ontario and the Maritimes pay considerably more (Canada Energy Regulator) — so a dryer that runs on recovered heat and draws little grid power protects the operating margin wherever it is sited.
Source: https://www.cer-rec.gc.ca/en/data-analysis/energy-markets/market-snapshots/2026/market-snapshot-how-much-do-your-neighbours-across-canada-pay-for-electricity.html · checked 2026-08
Domestic cement producers are a growing home for waste-derived fuel: Lafarge's Richmond, British Columbia plant aims to replace 50 per cent or more of its fossil-fuel use with non-recyclable by-products, and co-processing waste-derived biomass and other alternative fuels cuts emissions by roughly 20 to 30 per cent per tonne of coal displaced — creating real demand for a consistent, dried, high-calorific fuel.
Source: https://natural-resources.canada.ca/funding-partnerships/lafarge-canada-low-carbon-fuel-technology-expansion · checked 2026-08
Worked illustration (assumptions stated):
What dominates the numbers is the price of not diverting. A Metro Vancouver garbage fee of CAD 162 per tonne on commercial loads, plus surcharges where banned recyclables or organics are present, means every tonne turned into fuel or recovered material carries real value. A drier combustible fraction has a higher calorific value and weighs less to haul, and the federal carbon price of CAD 110 per tonne makes sending that fuel to a cement kiln in place of coal steadily more attractive. Designed to run on recovered heat instead of expensive grid electricity, FlowDrya protects the margin hardest in the higher-priced provinces. Assumptions: gate fees and offtake terms differ widely by province and contract.
Figures are indicative and were last reviewed August 2026; energy and disposal prices move — contact us for a current assessment.
Municipal Solid Waste Dryer Manufacturer in Canada — FAQ
Do you have a municipal solid waste installation here?
Not yet, and we will not imply one. Our documented British installations dry bark, digestate fibre and woodchips; they run the same FlowDrya platform an MSW drying plant would use.
Why dry municipal solid waste here?
Rising disposal costs, provincial organics bans and a growing carbon price push mixed waste toward recovery. A drier, more stable feed improves fraction separation and raises the calorific value of the fuel sent to energy-from-waste, so the plant recovers more from each tonne.
Which permits apply to an MSW drying plant?
A plant storing and treating municipal solid waste is authorised provincially, and any waste-derived fuel it produces for a kiln must be consistent and well-specified to be accepted. Requirements differ between provinces.
How does drying improve waste sorting and recovery?
A drier feed flows better across screens and separators, so metals, plastics and inert grit part more cleanly from the combustible fraction, raising recyclate purity and the quality of the recovered fuel.
What treatment routes suit dried municipal waste?
Mechanical-biological treatment, refuse-fuel production and energy-from-waste all perform better on a stabilised, low-moisture input than on heavy, decomposing mixed refuse.
Can dried municipal waste be stored before processing?
Yes. A stabilised, low-moisture output resists the heating and odour that plague wet stockpiles, so a plant can buffer material safely and feed downstream equipment at a steady, controlled rate.